|
- AC Delco R45TS gap out of the box - Team Chevelle
Just picked up a new set of plugs to go with my freshly installed HEI conversion, from Dave Ray, and they are all gapped at 045 I thought they were set up out of the box for points at 035 Maybe not, but will be at the outer limit for the HEI Just putting this out there for anyone running
- Stihl Ignition Module Air Gap. . . - Arborist, Chainsaw Tree Work Forum
Here's the problem, the stihl setting gage seems to set the air gap too tight, like 0 004" measured between the ignition module arms and the flywheel magnets using a feeler gage set It seems as though the center coil pick up on the ignition module has a wider air gap Now my question, what is the proper way to measure an ignition module air gap?
- Real world HEI spark plug gaps - Team Chevelle
The second was to make a spark great enough to bridge a slightly larger spark plug gap than a point system made, so, as fuel molecules were reduced for leaner mixtures for emissons, there would be enough gap in the plug to "catch a fuelk molecule" to light off the burn in the combustion chamber This took creating "drivrs" in the HEI module to increase dwell charge time to the coil, store
- Spark Plug gap on a 454 with Edelbrock 35830 EFI, 1971. . .
Hello All, Just looking to see what I should gap spark plugs to with a 454 using an Edelbrock 35830 EFI kit? I read 0 32-0 45, I'm leaning towards the high side Thoughts? Thanks, Tom
- 026 Ring gap. Too much? - Team Chevelle
Building a 454 030 overbore and pre gapped rings are 25 26 thou gap That is a bit more than I would like Mild street build Naturally aspirated ok, or do I have to buy file fit that cost a fortune? Will this gap give too much blow-by?
- Engine builders. . . . Ring end gap. Top ring vs 2nd ring
Both manufacturers say to use the same gap for both the top and second ring I had always went about 002" wider on the second ring for controlling blowby to reduce the risk of ring flutter What are the engine builders' on this site's thoughts on this? Set them to 019" 021" or 019" 019"?
- Flywheel gap??? | Arborist, Chainsaw Tree Work Forum
The business cars gap is the quickest way of setting and will be fine As for the tape on that fly wheel I have never seen anything on any flywheel like that on any machine from large to small I have worked on If you bought the saw second hand maybe that was the previous owners way of setting the gap?
- Spark Plug Gap - BBC - Team Camaro Tech
Things that determine resistance is the plug wire conductor (metal conducts better than carbon impregnated fiberglass strands), the spark gap, and the resistance in the plug (the R in the designation of an AC-delco plug denotes an internal air gap to prevent power from bleeding off too soon)
|
|
|