- How to Measure your Gas Struts - Lift Supports Depot
1 Measure the Extended Length 2 Measure the Retracted Length 3 Understand the Ending Types 4 Stroke Length Ensuring that you have the proper-sized lift support struts for your car is essential for your hoods, trunks, and lift gates to work correctly Knowing how to measure gas struts will help you make sure you get the right part for
- How can I Measure my Gas Struts, to find a replacement?
When learning how to measure gas shocks, struts, and lift supports, there are several things to consider Measure the Extended Length The extended length is the fully extended length of your support when measured from the center of the Ball Socket, Eyelet, or Rivet (if a bracket is used)
- How to measure a gas spring - YouTube
In this video, our MD, Matt Warne explains how simple it is to measure a gas spring and what tools you need to do this properly You will need a vernier, tape measure, and something to write
- How to Measure Gas Struts - Explained! - vehicleic
To measure gas struts, extend them and use a tape measure to measure the extended length Also, measure the rod length, which is the stroke length Then, measure the diameter of the road and the barrel using a vernier Finally, identify and match the end fittings before purchasing the new struts
- How To Measure Your Gas Strut
Learn how to measure you gas strut When replacing an existing gas strut, there are 4 measurements you will need to know before you start shopping
- How to measure gas struts? - apexstone. co
Have your old gas shocks worn out over time? Need to install gas struts replacement for your cabinet? No worries! I’m here to guide you with a simple, step-by-step method to measure gas struts If you find it useful, just click to bookmark the website, and you won’t have to remember any of the steps Let’s get started with the measurement
- How to measure a gas strut - Camloc
See how gas struts are measured using the correct terminology Where no end fits have been specified then the extended and closed lengths are measured from the rod end to tube end (excluding threads) as shown
|